|
Vacuum Pump Suction and Exhaust Filters
|
|
|
- Filters usable for vacuum pumps can be used for various types of vacuum equipment.
- Filter can be placed both suction and exhaust side.
- Reaction products and powders discharged from equipment are absorbed and collected by the elements of an ion exchange resin fiber.
- Not only powders in the exhaust gas but acid gas/oil-mist can also be captured efficiently.
- When the vacuum pump and pump oil are kept clean over a long period of time this can help to avoid a vacuum pump malfunction and reduce the number of oil changes.
- KF-clamps, reducers, center rings, etc. are additionally required for attachment (contact us separately.)
|
| Model |
SGT-100 |
SGT-200 |
| Filter system |
Out - In - Pass |
| Applicable models |
500L/min or less |
| Pressure range |
0.1MPa |
| Ambient temperature |
7 – 40 degrees C |
| Ambient humidity |
85% (non condensing) |
| Suction port |
KF-25 |
KF-40 |
| Exhaust port |
KF-25 |
KF-40 |
| Height |
154mm |
234mm |
| * |
Since the "SGT-200" uses two filter elements of the same size as the "SGT-100", the capture rate is doubled.
When a small amount of powder is mixed in with the suction gas, it is recommended to use the “SGT-100” in order to positively suction powder, use the “SGT-200”. |
|
top of page
ULVAC KIKO, Inc. |
Overseas Division |
TEL (81) 45-533-0206 |
FAX (81) 45-533-0204 |
Please contact us by E-mail → here |
|
|
|
